[Ripper5]

Hey you know on the stock Ion board when theres a grey button on it that you can push to go through full auto and ramping etc. well I pushed it and went through all the settings like ive done before and then got to the end of the settings and I took the battery out I put it back in later on and turned it on to shoot it because I had some air left and it wotn work even if the eyes are off how can I fix it?

[C.HUNTER]

you may have the dwell & or rate of fire set wrong, (i had my ion fail to fire until i got it right setting up my qev)
try setting your dwell all the way down, then adjust up 5 clicks at a time .
if that doesnt work , try setting your rate of fire all the way up , and adjust down 4 clicks at a time
(there are pretty good charts for these settings on the net)

if that doesnt work or you not comfortable messing with you ion,,,,, yer on your way to bastion then (recomended course of action of course)

good luck

(btw is there such a thing as a "factory reset" for the stock boards?)

This post has been edited by C.HUNTER: 07 January 2007 - 01:19 PM

[Tekk]

definately sounds like the dwell is too low...

[Ripper5]

K thanks everyone for the help haha unfortanatly I read these a little late and just took my gun to robyn at midway haha but thanks anyways and I trust him more then I trust my self so It should be good thanks for the help tho

[Ripper5]

its fixed now the trigger was over adjusted and wasnt makeing contact with the swith